Epoxy Crack Filler 2gl Kit

Specialty Coatings 195-118

$105.38

195-118 is a two component 100% solids epoxy crack filler designed for shallow repair on either vertical or horizontal surfaces. This product is easy to mix and use and has a non-critical mix ratio. Additionally, the product, because it is 100% solids formulation, can be applied thicker on horizontal surfaces when needed. Recommended for filling cracks and defects in concrete or masonry.  This product can be topcoated immediately.

A two component 100% solids epoxy crack filler designed for shallow repair on either vertical or horizontal surfaces.  This product is easy to mix and use and has a non-critical mix ratio.  Additionally, the product, because it is a 100% solids formulation, can be applied thicker on horizontal surfaces when required.

  • Easy to mix 1:1 ratio
  • Fills cracks up to 1/8”
  • Fill holes, voids and surface irregularities

 

RECOMMENDED FOR:

Recommended for repairing cracks and defects in concrete or masonry.

SOLIDS BY WEIGHT:

100%

SOLIDS BY VOLUME:

100%

VOLATILE ORGANIC CONTENT:

Less than 11 g/l

COLORS AVAILABLE:

Gray (when mixed)

RECOMMENDED FILM THICKNESS:

1/8” cracks or thin build repairs.

COVERAGE PER GALLON:

0.13 cubic feet or 1,228 lineal feet @ 1/8” x 1/8”

PACKAGING INFORMATION                              

2 gallon kit= 1 gallon part A @ 11.1 pounds and 1 gallon part B @ 11.2 pounds (22.3 pounds net).

10 gallon kits (111.5 pounds net)

(volumes and weights approximate)

MIX RATIO:

1 part A to 1 part B by volume

SHELF LIFE:

6 months in unopened containers

CURE SCHEDULE:  (70°)

pot life – 2  gallon volume ………..…………...…………... 1-3 hours

tack free (dry to touch)…………...………………………. 5-10 hours

recoat or topcoat…………………..….. immediately after application

light foot traffic...…………………………………...……   10-24 hours

full cure (heavy traffic)... ………………….....................…2-7 days

APPLICATION TEMPERATURE:

60-90 degrees F.

PRIMER:None necessary

TOPCOAT: Optional:  This product can be overcoated with many suitable epoxy and urethane products.

LIMITATIONS:

*Color stability may be affected by environmental conditions such as high humidity, chemical exposure, or exposure to certain types of lighting such as sodium vapor lights.

*Colors may vary from batch to batch.

*This product is not UV color stable and may discolor when exposed to UV light sources.

*Substrate temperature must be 5°F above dew point.

*All new concrete must be cured for at least 30 days prior to application.

*Many epoxy products can be placed directly over the uncured epoxy crack filler immediately after the material is used provided that the cracks are small.  If coating over repairs that are larger, it may be advisable to allow the material to become tack free prior to application of subsequent coatings.

REFER TO TDS FOR MORE INFORMATION: