100% SOLIDS TWO PART EPOXY PATCH KIT

Specialty Coatings 197-8006/45

$55.00

This two component, 100% solids epoxy coating system is designed to fill eroded, cracked or damaged concrete. The 100% solids formulation of the light gray patching material exhibits minimal shrinkage upon curing. Offers outstanding abrasion and chemical resistance properties. Not to be used as a substitute for repair of structural defects.  

Covers approx 4.5 sq ft at 1/4".

COLOR IS LIGHT GRAY TO BLEND IN WITH CONCRETE  

 Description

This two component, 100% solids epoxy coating system is designed to fill eroded, cracked or damaged concrete. The 100% solids formulation of the light gray patching material exhibits minimal shrinkage upon curing. Offers outstanding abrasion and chemical resistance properties. Not to be used as a substitute for repair of structural defects.

 Surface Preparation

All surfaces to be patched must be clean, dry and free from dirt, grease, oil, chalk, efflorescence, curing and sealing compounds, soap residue and any other foreign matter. New concrete surfaces should age at least 30 days before being patched. Old concrete that is unsound, including flaking and spalling, must be removed to a solid substrate. Clean the surface thoroughly, rinse completely with clean water and allow to dry.

 Package Contents:       

  • Part A Hardener             1 – Quart Can                1.1 lbs
  • Part B Epoxy Resin       1 – Gallon Can               3.6 lbs
  • Part C Aggregate           In bucket                     14.5 lbs.

 

The items above are packed in a 5 gallon pail which can be used as a mixing container.

Coverage is approximately 4.5 square feet at 1/4" thick.

Shipping Weight – 24 lbs.

 

 INSTRUCTIONS - READ THOROUGHLY BEFORE STARTING

1.         Remove all contents (including aggregate) from 5 gallon bucket, set aside.

2.         Pour Part B Resin into container; scrape sides to remove all resin.

3.         Add Part A Hardener into Resin; scrape sides.

4.         Mix these two components thoroughly. POT LIFE IS 15 - 20 MINUTES AFTER MIXING.

5.         Pour aggregate slowly while mixing. Use Jiffy mixer or equal, if available. If hand mixing, use               disposable paddle.

6.         When thoroughly mixed, apply to surface or holes to be patched.

7.         For surface application, use straight edged or saw tooth edged trowel; for patching holes and               cracks, use masons trowel to smooth material.

 

CAUTION:  Wear gloves when handling patch kit. If mixture gets on skin, it is EXTREMELY difficult to remove. Vinyl hospital gloves work well. Discard gloves after use.

 CLEAN UP:  Metal Tools - Use paint stripper, or if outdoors, may apply flame from hand torch.  Resin will char and then crumble. Hands - If material dries on hands, mix ordinary mortar mix with water and rub this on hands until epoxy is rubbed off.

 The information and data given herein are based upon tests and reports considered reliable and believed to be accurate. However, due to circumstances beyond our control including but not limited to surface preparation, application technique, substrate and curing conditions, no guarantee of duplicate performance, expressed or implied, is made.