Industrial | Automotive | Military | Marine | About Us | Products | Contact Us | Home  
Industrial Coatings Automotive Coatings Military Coatings GSA

Acrylic Modified Alkyd Quick Dry Enamel

Product Data/Application Instructions

  • High quality, quick dry enamel for a "baked on" appearance
  • Can be applied direct-to-metal or over suitable primers
  • Available in standard and custom colors
  • Low VOC and contains no heavy metals
  • Can be catalyzed for improved gloss and color retention and increased chemical and abrasion resistance

A high gloss, direct to metal acrylic modified alkyd enamel that provides outstanding adhesion, durability and overall performance. Corrosion inhibitors allow this product to be applied with or without a primer. An ideal product for use on trailers, racks, cranes, machinery and heavy equipment. This product may be catalyzed for increased performance. Not recommended for use in immersion service. This product is lead, chromate and mercury free.

Surface Preparation

Surface must be free of moisture, grease or other contaminants. Remove loose paint, mill scale, rust, etc by hand tool cleaning (SP2), power tool cleaning (SP3) or abrasive blasting.

Spray Application

The following is a guide; suitable equipment from other manufacturers may be used. Adjust pressure and tip size for proper spray characteristics.
Airless, air assisted airless or conventional spray – Industrial equipment such as DeVilbiss,Binks or Graco.

Physical Data

Finish:

  • High Gloss 85% Minimum
  • Color: Unlimited colors available
  • Resin Type: Acrylic modified alkyd
  • Typical volume solids: 51% +/-2.0
  • Theoretical Spread Rate: 550-650 Sq. Ft. Gal.
  • Recommended film thickness: 1.2-1.5 mils dry
  • VOC: Less than 3.5 lbs./gal.

Application Data

  • Method: Airless or conventional spray, limited brush
  • Temperature: Minimum 50°F air and surface. Surface temperatures must be at least 5°F (3°C) above dew point to prevent condensation.
  • Drying time: @ 77° F & 50% RH
    • Tack free: 10 minutes
    • Recoat/Handle: 2 hours
    • Dry hard: 16-24 hours (non catalyzed)
  • Reduction: Xylene
  • Clean up: Xylene

Custom factory packaged colors available 50 gal min., 10 days lead time

Shipping Data

  • Packaging: 1,5 and 55gl drums
  • Shipping weight (approx) 9 lbs/gl
  • Shelf life: 12 months

Numerical values are subject to normal manufacturing tolerances, color and testing variances. Allow for application losses and surface irregularities.

SC951 Acrylic Modified Alkyd Quick Dry Enamel - Downloadable Tech Data Sheet (86 KB PDF)

 

What's new at SCI

Visit our new location in Port Huron - view the map for directions.

Our new, larger facility is on Kelly Road in Fraser - view the map for directions.

SCI Line Cards

Download or print SCI line card to keep at your desk for when your looking for products for a job.